I remember a little pop-up backyard tent I had as a child. My brother and I spent hours making it a fort, a castle, a post office and so many other things.
Unfortunately, all that survived of that tent is our childhood memories, but I wanted to find something similar that my children could play with outside during the summer. I wanted something easy to store and that provided shade but that wouldn’t block the breeze either…
DIY Burlap Tent…
So of course, Burlap was the perfect choice.
I’ve used burlap for everything from garland for the Christmas tree to table runners and picture frames. A friend used it for some gorgeous DIY curtains.
Burlap is so versatile and I love the natural look.
After we designed it, the building of this project was a grandfather/grandkids activity and they had a blast. Here’s what we did…
(7) 1 x 2 cedar boards (8’ long)
(12) deck screws – 1½” long
(2) deck screws – 3” long
4 washers (approximately 1” diameter)
(1) roll of sisal or jute twine
4 yards of burlap or canvas material 48” wide
3/16” drill bit
1/8” drill bit (for pilot holes)
How to Build it
Cut the 1 x 2’s into the following lengths: four pieces at 72”, one piece at 49¾ ”, four pieces at 48”.
Drill a 1/8” pilot hole into the center of each end of the 48” pieces and the 49¾” piece.
NOTE: All remaining holes will be 3/16”.
For each of the 72” pieces, drill holes in the center of the 2” face at the following locations:
6” from one end of each board (Hole #1)
1½” from each end of each board
Every 12” from one end of each board
(This will result in 8 holes in each 72” board.)
Insert a 3” screw into Hole #1 of one 72” board. Place two washers onto the screw. Insert this assembly into Hole #1 of a second 72” board. Attach this onto the end of one 48” board. Do not tighten completely. Repeat this process to attach the remaining two 72” boards to the other side of the 48” board. The 72” boards are the legs of the Teepee Tent.
Open each pair of legs so that the outside boards are on the same side. Attach the 49¾” board to the bottom of the outside legs using the shorter screws through the hole 1½” from the end of each leg. Attach one of the 48” boards to the inside legs using the same procedure.
Insert the twine into the bottom hole in one front leg and pull it through the corresponding hole in the back leg. Tie the twine to each leg so that it does not sag. Repeat for each pair of holes on both sides.
Staple the end of the burlap or canvas material to one of the remaining 48” boards. Wrap the material around the board and attach this to the 48” board at the bottom of the tent. Weave the material over and under each string and over the top 48” board until it reaches the bottom of the other side. Staple the material to the remaining 48” board, wrap the material around the board, and then attach this to the 49¾” board.
Open the tent to the width desired. Insert a piece of twine into the holes at the top of the two 72” boards in the front of the tent and tie into a loop to prevent the tent from opening wider. Repeat this on the back legs.